You can use the Bully Dog Car Rear View Mirror Mount for mounting to the car’s rear view mirror. But, as stated previously, works well if you allow the Bully Dog to rest on the dash. If used to maintain the Bully Dog without a support on the bottom, it will shimmy to the point where it can get distracting. I find these types of mounts work best when you allow the device to rest on the dashboard. This is a flexible gooseneck mount that can bend in any angle. The Bully Dog Universal T-Slot Suction Cup Mount is a little less heavy duty that the one we just discussed but can typically be found for a lower price. There are pre-drilled mounting holes so you just need to add some mounting screws for attachment.

It would take the place of the suction cup assembly. If you would like to drill a hole somewhere, simply add the RAM Flat Surface Mounting Base to the existing mount. It’s a very stable mount with minimal (if any) shake or shimmy from car vibrations.Ī nice feature about the mount above is that any of RAM’s adapters with 1″ balls will fit the arm that comes with it. The total length of the mount is about four inches. There is an included single T adapter that fits the back of the tuner. This means that you can adjust the angle from the base and the adapter. There is an included arm that works like a ball and socket. It can also mount to anything that is smooth and flat such as a plastic surface. Turn the twist lock when the suction assembly is attached to your windshield and it locks to your windshield tightly. The suction cup assembly is RAM’s twist lock mechanism. The Bully Dog Suction Cup Mount is a collaboration between Bully Dog and RAM Mount. Also be sure there is no tinting film on the windshield as a mount will not work well and may wind up pulling the tinting film off the windshield. You can use any good alcohol based cleaner such as Windex to do that. Be sure your windshield is clean before attaching any suction cup mount. The most popular mounting location for a Bully Dog GT or WatchDog is the windshield. The mounts we discuss should fit fine, especially those marketed directly by Bully Dog themselves. I have found that not all single T mounts will fit a Bully Dog well as some of the tabs were made too thick or too thin. That single T slips into the slot, and when you push it to the left or upwards (depends upon the slot configuration on the back of the tuner), it locks in. The mounts that are discussed in this article have a tab, also known as a single T ending. The back of the Bully Dog Tuner will have a port for the connector and right above that is a slot. It’s fairly simple to mount these tuners. This article speaks to mounting options for the popular Bully Dog GT and WatchDog Tuners. A tuner is typically used to improve engine performance and can result in better MPG. The custom tunes are typically created by a tuning company that specializes in this service. The Bully Dog GT Gas Tuner allows tuning of certain car engines.

Bully dog tuner mount